Single phase motor -ML 80B 0.75 kW 4pol-B35
Single phase motor with Operating and Starting capacitor
Power= 0.75 kW, Speed= 4 pole, Voltage= 1 x 230 V (± 5% according to VDE 0530),
Weight= approx 10.8 kg, Shaft = 19 x 40 mm, Frequency= 50 Hertz, Degree of protection= IP55, Operating mode= S1- 100% ED.
Paint= RAL 5010 (gentian blue), Temperature sensor= 1 x PTC- Thermistor. Cooling= axial fan,
Insulation class = F (155 ° C), Terminal box position= top, Housing= die-cast aluminum,
Ball bearing= SKF, C & U, o. equivalent, Motor feet= screw-on resp. can be unscrewed.
Single phase motors are suitable for both directions of rotation.
Optional:
On / off switch with reversing switch for left / right rotation, underVoltage release,
Collar connector = 1 x 230 V, switching capacity = 16 A, ambient temperature = -5 ° C to + 40 ° C,
Cable between motor and switch housing = approx. 90 cm.
Generally:
Owned by the starting and operating capacitor the 230V motor has a stronger starting torque.
The starting capacitor is switched off when the Speed is reached by a centrifugal switch.
Speed control via frequency converters or the like therefore leads to faults and is not permitted.
When the load is low, the temperature in the motor rises sharply and this can lead to failures.
It is therefore recommended not to operate Single phase motors with a load below 25% of the nominal load.
All product photos are non-binding Examples !
| Ambient temperature: | 40 °C |
|---|---|
| Breakdown to nominal torque (Mk/Mn): | 1,75 Nm |
| Current: | 4,56 A |
| Direction of rotation: | Left, Right |
| Efficiency (100% / 75% / 50%): | 73,0 |
| Efficiency Class: | IE 1 |
| Engine protection: | PTC thermistor single |
| Flange dimensions: | 200 x 130 x 165 mm |
| Frequency: | 50 Hz |
| Installation altitude: | 1000 m |
| Operating mode: | S1 |
| Performance: | 0,75 kW |
| Pick-up to rated current (la/In): | 27,00 A |
| Power factor: | 0,98 Cos φ |
| Protection class: | IP55 |
| Rotation speed: | 1500 rpm / 4 polig |
| Shaft diameter: | 19 mm |
| Shaft dimensions: | 19 x 40 mm |
| Tension: | 1 x 230 V |
| Tightening to nominal torque (MA/Mn): | 2,50 Nm |
| Torque: | 5,26 Nm |
| Type of construction: | B3 B5 (B35) |
| Weight: | 10,9 kg |
Accesories
